Kenwood KR-300HT Instruction Manual page 28

KRQOOHT [En/K}
normal condition.
ity to
T:Unplug the AC power plug from the wall outlet.
DWhile holding the POWER switch depressed, plug the AC
plug into the power outlet.
@Piease note that resetting the microcomputer clears the contents
stored in and returns to the condition when it left the factory
Amplifier
Sound is not output or the volume level is
@ The speaker cords are disconnected
The SPEAKERS keys are set to OFF @ Set the SPEAKERS key to ON fz
@ The TAPE 2 MONITOR key is set to ON e@Set the TAPE 2 MONITOR key to OFF.
Set the input selector to the position other than
tuner.
} —
Connect them property referring to "Connec-
The STANDBY indicator blinks and sound is
not output.
e Speaker cords are shortircuited Turn the power off, eliminate the short-circuit
Ing, then turn on the power again. U8
Sound is not output from one of the speak-
ers.
e@The speaker cord is disconnected
@The BALANCE control is set to an extreme
position
e Connect it properly referring to "Connection of
speakers"
@ Adjust the Left/Right balance
Sound is not output from the surround
speaker and/or center speaker, or theirsound
is very small.
@ The surround speaker cords and/or center speaker
cord are disconnected
@ The Surround play mode has not been engaged
e@ The surround and center speaker levels are set to
the minimum positions
@ Connect them properly referring to "Connec-
ton of speakers" Ce
Set the presence mode. (22.
@ Adjust the surround and center speaker levels.
A hum noise is generated when the PHONO
input is selected.
@ The audio cord from the turntable 's not inserted
securely into the PHONO jacks.
@ The turntable is not grounded
elnsert the audio cord plugs securely into the
PHONO jacks (4.
@ Connect the grounding wire to the GND termi
nai on the rear panel
System control is not available when TAPE1
or MD is selected.
e@"TAPE1" of "MD" Is not displayed
e Switch the display to TAPE tor MD.
GE -e
System control is not available.
@ The XS8 and SL16 modes were switched while
the AC plug ts left plugged into the wali power
outlet
@ Unplug the AC piug from the wall outlet and
switch the XS8 or SL16 mode as required
"iE
Display is dimly lit.
@ Fhe setting 1s not correct
@ Adjust the bnghtness with the DISPLAY key.
oe
Tuner
Symptom.
Cause
Radic stations cannot be received.
@ No antenna is connected
The broadcast band ts not set properly.
@ The frequency of the desired station isnot tuned
@ Connect an antenna -e
@ Set the broadcast band properly. =
e Tune the frequency of the desired station. _
wah
Interference.
@ Noise due to ignition nase of an automobile
@ Noise due to an influence from an electric appli-
ance
@ Noise due to a nearby TV set.
elnstall the outdoor antenna away from the
road
Turn off the power to the appliance.
elnstall the system farther away from the TV
set
A station which was preset cannot be re-
ceived by pressing the corresponding mu-
meric key.
eThe preset station belongs to a frequency that
cannot be received
eThe preset memory was cleared because the
power cord had been unplugged for along period
of time
@The TUNER input is not delected
e Preset a station with 4 receivable frequency
@ Preset the station again
Select the TUNER input