Kenwood KR-300HT Instruction Manual page 26

The Sound Retrieval System is an epochal system which
produces a three-dimensional sound space by applying the
most suitable processing to the sound signal on the basis of
the human listening mechanism. This permits real depth
and sound location, considered as difficult to realize with
conventional 2-channel stereo (general stereo). A sufficient
effect can be obtained for any source (CD, tape, broadcasts,
etc.).
Adjusting the tone.
SRS 3D Stereo (Sound Retrie
KRS3OOHT [En/K)
lit.
© Turn the SRS 3D stereo ON.
SRS 30
tu
© Abjust the effect strength (level).
played.
SOUND
on
Increasing the "CENTER" tevel en-
hances the feeling of depth around
the center.
the sound expansion wider.
(2) Adjust the level.
To increase a
tne levei > |
To decrease (> aN
\ tne lever See
—— a
@ Ensure that the S.DIRECT indicator is not [
(1} "CENTER" or "SPACE" should be dis- [ |
increasing the "SPACE" tevel makes
Even if the sound is recorded while the SRS 3D stereo
effect is applied, the effect is not recorded together with
the source sound.
| ~ Ti :
i Lt '
Each press of the key switches the modes as follows:
@ SRS 3D is lit
[ : SRS 30 STEREO ON
@ SRS 3D is not lit
venneee. SRS 3D STEREO OFF SBRRO SPEAKERS
STANDBY ° °
Lights
Each press of the key switches the modes as follows:
: Mode for adjusting the depth of SRS 3D.
[ : Mode for adjusting the expansion of SRS 3D.
@ End of setting
@ The BASS, MIDDLE and TREBLE adjustments are not available
while the SRS 3D Stereo is ON. For the BASS, MIDDLE and
TREBLE adjustment procedures. "i
The level value varies
e@ Adjustment is possible in the range from 1~7.
@ Please set as desired according to the titles being played back etc.