Kenwood KR-300HT Instruction Manual page 22

Select the DOLBY PRO LOGIC surround mode.
PRO LOGIC
Non
KR-BOOHT [En/K]
CENTER
MODE
e@Select a surround mode according to the played source and your
system components. Lights
re
| moore Mm Th
i rUPU bt hoo ob
3 | Set the sub-woofer.
only).
"SUB ON" or
"SUB OFF" is
displayed.
© Press the SETUP key to set the selection.
When the selection is set, the unit enters
speaker balance".
The input sources are switched in the following order.
(2 NORMAL — : When the center speaker is a compact
speaker.
( WIDEBAND : When the center speaker is alarge speaker.
<3) PHANTOM : When no center speaker is used.
@ Press the SETUP key (remote controlunit |
the condition for "@ Adjust the front |
Adjust the front speaker balance.
@Ensure that the balance setup is dis-
played.
identical.
To decrease the =>
left channel sound € >
LEVEL
oo SEN
To decrease the —<_—) ee
right channel sound "7
the setup.
After this, the unit enters the condition
for "El Adjust the volume level of each
Adjustment procedure: Each press of the SETUP key switches the
adjusted items as shown below.
Setting the sub-woofer
@ Adjusting the front speaker balance
G@ Adjusting the volume level of each speaker
G Adjusting the delay time
End of setup
To cancel setup in the middle, press the SETUP key repeatedly until the
setup mode is cancelled.
Each press switches the sub-woofer as follows.
@ Adjust the front speaker (left & right)
levels so that the left and right levels are |
© Press the SETUP key again to establish |
speaker".
i? T SUB ON : Sub-woofer ON
@ SUB OFF : Sub-woofer OFF
Left speaker Center position Right speaker
position indication positron
\
| SURROUND
Balance setup