Kenwood KR-300HT Instruction Manual page 12

Turn the power ON.
2 | Select the SPEAKERS key setting.
A-SPEAKEAS-B
FS 20 _SPEAKERSS
wren © 185 8
Light up tne indicator of the desired speakers
El Select the input source.
KR-3OOHT [En/Kk}
i
000 000 Ja'oro:
bom
OOO 00 18 O10
10 0 0
Q@
Oke O.
ul
iene
a
Keys or controls to be used in this operation
B can be switched by operating the SPEAKERS A and
B keys as described below.
For the speaker connection method: oe
cs The sound output from SPEAKERS A and SPEAKERS
Note)
A,BOFF ; The speakers do not output sound. Use this position when
listening sound through headphones, etc
AON The speakers connected to the SPEAKERS A terminals on
the rear panel output sound
A OFF The speakers connected to SPEAKERS A, center speaker
and sub-woofer do not output sound
BON The speakers connected to the SPEAKERS B terminals on
the rear panel output sound
A,B ON The speakers connected to the SPEAKERS A and B termi-
nals on the rear panel output sound simultaneously
@When the surround mode is entered while both SPEAKERS A and B are
ON, SPEAKERS B are turned OFF automatically
If the SPEAKERS B key is pressed at this time, SPEAKERS B are turned
ON, and the surround mode is canceled
@When the surround mode is entered while SPEAKERS B are ON,
SPEAKERS 8B are turned OFF automaticaliy, SPEAKERS A are turned
ON and surround play starts.
INPUT SELECTOR
Play the selected source.
Gi Adjust the volume.
The input sources are switched in the following order:
*1: Switching the VIDEO1 display to TAPE1 or MD display
When a KENWOOD cassette deck or MD recarder is connected in the
[SL16] system control mode, the VIDEO 1 input should be switched to
the TAPE1 or MD input with the following operation
@Select VIDEO1 with the INPUT SELECTOR. .
@Press and hold the AUTO key for more than 2 Not)
seconds to select TAPE1 or MD.
f
@VIDEO1 — @TAPET
1
@MD
VOLUME CONTROL
(CY)
To decrease To increase
volume Down up volume
Volume level is displayed
| i Tm 41 Th
l
miowe ad
no Qc co i
@The time taken till the volume level is displayed is variable depending
on the current operating condition
Rotating the VOLUME CONTROL at a higher speed increases the
amount of volume change (Al VOLUME function}
The sound of input source cannot be listened to while TAPE 2
MONITOR is ON