Replacing The Saw Blade; Riving Knife / Splitter; Operation; Initial Operation - Mafell PSS 3100 SE Original Operating Instructions And Spare Parts List

These specifications can also be found on diagram 2
(Fig. 1) that is attached to the operator panel. From
this diagram you can gather the matching feed
speeds.

4.5 Replacing the saw blade

Danger
Pull the power plug during all
service work.

Do not press the locking bolt 4 (Fig. 2).

Using the Allen key 3 (brackets Fig. 2), unfasten
the flange screw 5 (Fig. 3) counter clockwise;
remove the screw as well as the front clamping
flange 6.

You can now remove the saw blade by lifting it
to the front and pulling it away with a downward
movement. Removing the saw blade is made
easier if you tilt the system that far that the saw
blade is automatically released from the rear
flange collar.

The clamping flanges must be free of adhering
parts.

Pay attention to the sense of rotation when
inserting the saw blade.

Afterwards, mount the clamping flange, attach
the flange screw and tighten it by clockwise
turning.

In doing so, keep the locking bolt depressed.
Do not press the locking bolt 8 (Fig.
2) with the machine running! The
machine may get damaged.

4.6 Riving knife / splitter

Danger
Pull the power plug during all
service work.
The riving knife / splitter 8 (Fig. 3) prevents the saw
blade from jamming during longitudinal cutting. The
correct distance to the saw blade is shown in Fig. 5.

Set the saw blade to the largest cutting depth
(see Section 5.3).

For adjustment, unfasten the two cylinder-head
screws 9 (Fig. 4) with the Allen key supplied
with the saw 3 (Fig. 2).

Adjust the riving knife / splitter by shifting it in its
longitudinal slit. Afterwards retighten the two
cylinder-head screws.
5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular attention
instructions".

5.2 Switching on and off

Danger
Pay attention that the saw blade
moves freely and does not make
contact with the workpiece. Lead
the connecting cable and extraction
hose away to the rear.

Switching on: To turn on the saw blade drive,
press the rocker switch 22 (Fig. 1) in direction
and keep it depressed.

Switching off: To switch off the saw blade
drive, release the rocker switch 22. The infeed
and the saw blade drive are immediately
switched off. The saw blade will come to a
standstill in less than 10 seconds.
Danger
The saw blade immediately starts if
the switch is pressed, shortly
afterwards the infeed starts
automatically.

5.3 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 45 mm (0 to 1 ¾ in.).
-27-
to the chapter "Safety