Service And Maintenance; Storage; Transport; Disposal Of A Rechargeable Battery - Mafell K55 18M bl Operating/Safety Instructions Manual

K55 18M bl / KSS50 18M bl
Use the following procedure to adjust the cutting
width:
1. Loosen the wing screws (5) on both sides.
2. Adjust the roller edge guide.
3. Tighten the wing screws (5) on both sides.
The cutting width is adjusted.
✓
5.10.2 Working with the guiding device
The description for the guiding device can be found in the enclosed instructions "Guiding
device L/M/ML/S".
6

Service and maintenance

MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.

6.1 Storage

Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.

6.2 Transport

When you ship the rechargeable batteries, ensure that certain special requirements are satisfied with regard to
packaging and labeling. The contained Li-ion batteries are subject to the requirements of the regulations for
hazardous materials.
Ship rechargeable batteries only when their housings are undamaged.
Prior to shipping, stick non-conductive tape (e.g. insulating tape) across the battery terminals and pack the
batteries such that they cannot move inside the packaging.
Please ensure that you observe any further national regulations too.

6.3 Disposal of a rechargeable battery

Never dispose of rechargeable batteries in the domestic waste! Defective or exhausted rechargeable batteries
must be collected separately and recycled in an environmentally friendly manner.
Drop off rechargeable batteries at certified battery electronics recyclers.
01/2022
Fig. 24: Adjusting the cutting width via the roller edge guide
27