Mechanical Installation
5.4
Mounting the Drive
The servo drive supports backplate mounting only.
Note
Servo drives in sizes A and C are secured by two screws, with one screw on the top
●
and the other one at the bottom.
Servo drives in size D are secured by three screws, with two screws on the top and
●
another one at the bottom.
Servo drives in size E are secured by four screws, with two screws on the top and
●
the other two at the bottom.
5.5
Installing the Motor
Installation Direction
The MS1 series motor is flange‑mounted. It can be mounted in three directions, as
shown in the following figure.
Figure 5‑2 Backplate mounting
‑
‑
26