Listening To The Radio - Denon DCT-950R Service Manual

(Europe Version)
Listening to the Radio
1 Press @ button to turn the tuner on.
2 Press the @ button to select one of the FM or MW
bands.
meee ——> FM2 + FM3 —_—> MW1 ———> a
3 Use the seek buttons to set the desired frequency.
There are two ways to adjust the frequency, as explained
- below.
"ST" appears on the display when a stereo broadcast is
received.
(1) Seek Tuning
Press the @ Pes) button and check that "SEEK" has
TERS
appeared on the display.
Press this button to move to lower fre-
quencies. Tuning stops automatically
when a station is found.
Press this button to move to higher fre-
quencies. Tuning stops automatically
when a station is found.
Tuning will not stop at stations whose signals are weak. To tune in such
stations, use manual tuning.
e Press the ® button to search for only stations with
strong signals when tuning in the seek mode.
Exampie: Preset 102.5MHz at preset button 1 for FM1: .
Using the Automatic Memory System
(2) Manual Tuning
If "SEEK" is displayed on the display, press the ®
button to turn it off. ioe
The frequency decreases in steps of 50
kHz for FM and 9 kHz for MW each time
this button is pressed.
The frequency increases in.steps of 50 kHz
for FM and 9 kHz for MW each time this
button is pressed.
Press preset button 1 (@ (1,-'}) and hold it in for at least two
seconds.
After about two seconds, a "beep" is heard.
"CH1" appears on the display. The station is now preset in the
memory.
Use this procedure to store other stations. To tune in preset
stations directly, simply press the button at which the station was
stored.
buttons.
2 Press the @ button and hold it in for at least 2 seconds.
at preset buttons 1 to 6. '
NOTE:
stations are replaced by the new stations.
on the display.
etc.
Presetting Scanning
Mono Function (Auto/Mono Selection)
This function lets you check the stations stored at preset
buttons 1 to 6. '
Press the ® button for at least 2 seconds.
The stations are received in order for 5 seconds each.
This function is used at the time of FM reception when the
stereo broadcast is hard to hear or when there is noise
interference. It changes the stereo reception to monaural.
Press the @ button for more than 2 seconds.
e Even when the this function is used, there are occasions
when the sound is not improved, depending on the reception
conditions.
17
DCT-S50R mi
21