Denon DCT-950R Service Manual page 26

mg DOCT-S50R
CEurope Version)
Random Play
(1) One disc
1 Press the ® button once. "RND / " appears on the
display, and the tracks on the disc which is currently playing
are played in random order.
To move to the next track (selected in random order) when in
the middle of a track, check that "SEARCH" is displayed on the
display, then press the @ ® button.
To cancel the random play function, either press the ®
button twice, or press another CD control button.
® "RND" is displayed if no changer is connected.
bSiiz4 ® {
=p AND {
aise TRAGK |S SERCH
i
Error Displays
If any of the following error displays are shown on the display when
the unit is operated, carry out the measure indicated in the table.
26
Time Adjustment
ay 6) \C—) DENON aaeros for ET
OS BOnee
Time display: Pressing the ® (= ] button provides a time
display for about 5 seconds. ,
1. Automatic adjustment
@ The clock is automatically adjusted by the RDS CT (Clock Time)
function.
If the ® [=] button is pressed after the clock has been
adjusted with the CT function, "CT" is displayed in front of the
time display.
Telephone Mute
(2) All discs (Please connect CD Changer}
1 Press the ® [8 awn ®| button twice. ""RND c'" appears on the
display, and all the tracks on ail the discs are played in random
order.
2 When the @ ® button is pressed, during the automatic
search mode (when "SEARCH" is displayed on the dispiay)}, a
randomly selected track on a randomly selected disc starts
playing.
© To cancel the random play function, either press the ®
button until "RND | ", or "RND - " disappears, or press
another CD contro! button.
She pes fs )
oisc Track |S SERCH
e With this function, only the discs in the CD changer are played
in random order.
dit | __ cue ow
Insert a disc magazine that has
been loaded with discs into
the changer.
The disc magazine is not
NO MAG. inserted in the changer.
l e af Remove the disc magazine and
in the disc magazine. oad the discs.
ERROR | Troubleshooting Push the DCT-950R reset switch,
The temperature protection ' ; :
HOT | circuit of the OCH-700/600/500 | Wait until the temperature
has operated. Ps.
All of the discs in the magazine Set the discs properly or wipe
DISC REV are upside-down or dirty. off the dirt.
The temperature protection
SC HOT j circuit of the CD Mechanism
has operated.
Wait uniti the temperature
rops.
The clock may not be properly adjusted when receiving
stations from areas in different time zones. :
Some RDS stations do not offer the CT service.
Automatic adjustment may not be possible when reception is
poor due to the inability to receive the CT code.
To use the automatic clock adjustment function, the unit has to
be tuned to an RDS radio station for an average of 30 seconds
before using this feature.
2. Manual adjustment (only operates in the OFF mode)
When the ® button is pressed for more than 2 seconds,
the back light"and display turn on.
Adjust the Hour setting with the @ or@ & buttons.
Press the @ ( " ° J button. The Minute display will flash and the
minute adjustment mode will be set.
Adjust the Minute setting with the @ or @ &
buttons.
Press the ® button again. The time will start advancing
from the adjusted time setting.
Note:
e The time is displayed with a 12-hour display; there is no A.M.
or P.M. indication.
e The time cannot be adjusted manually when the set is
operating.
1. When terminal @ is connected to a car telephone, the volume is automatically decreased when a call is received.
e "TEL MUTE" appears on the display.
e@ The volume returns to the previous level when the telephone is hung up.
Note: There is a possibility that the telephone mute function will not operate with the telephone that is used. !n view of this, please be sure
to discuss this matter with the installer or the service representative when you have decided to install a telephone.
26