Mechanical Leveling Cylinder Stops - Hillco JH7020 Operator's Manual

Mechanical Leveling Cylinder Stops

In the event of electrical controller or hydraulic
failure Hillco requires installation of mechanical
Leveling Cylinder Stops on combines equipped
with oversized drive tires that limit leveling. With
certain oversized tires leveling must be limited.
The Leveling Cylinder Stops will prevent side
panel or tire damage. Contact Hillco for further
details.
Stops are available in two thicknesses, 5/8" and
1/8" for adequate adjustment. If additional stops
are needed contact Hillco.
See the "Max Level Calibration" section for
instructions on how to place the leveling cylinder
stops.
Notice
D-180215CMA01C
In some tire configurations, the tire can contact the gull
wing doors or the ladder. In this case, the maximum
level must be adjusted to prevent tire contact with the
combine chassis. However, to prevent chassis and
tire damage in the event of a hydraulic or electrical
failure, Hillco strongly recommends that cylinder stops
be installed on the leveling cylinders. Hillco is not
responsible for chassis damage that occurs due to the
lack of appropriate cylinder stops.
Hillco Technologies, Inc.
A
A - Mechanical Leveling Cylinder Stops
(5/8" thick Cylinder Stops Shown)
47
Sept. 2022