Table of Contents
Advertisement
Overcarriage Position Indicator
Attached to the overcarriage and undercarriage
is the position indicator (A).
indicator outputs a signal to the controller
of
the overcarriage position relative to the
undercarriage. This also acts as a maximum
level indicator. When the combine is nearing
maximum level the controller reduces the amps
to the leveling valve decreasing the hydraulic
flow. This provides for smooth leveling when
achieving maximum level.
Slope Sensing Clinometer
Located
on
the
Overcarriage Position
Sensing Clinometer (B). This clinometer outputs
a signal to the controller. This output is a value
that tells the controller the chassis' position
relative to level.
This same clinomter also outputs a fore/aft slope
reading. This signals an alarm that is displayed
on the monitor when the combine is pointed
down a hill that is greater than 20% and the rear
wheel assist is engaged.
Transition
The transition is added to the front of the feeder
house to pivot the header and allow it to follow
the contour of the ground.
D-180215CMA01C
The position
overcarriage
near
Indicator is the Slope
Hillco Technologies, Inc.
A - Overcarriage Position Sensor
the
B - Clinometer
D - Transition
14
A
B
Sept. 2022
Advertisement
Table of Contents
