Header Position Sensor; Retractable Ladder Step - Hillco JH7020 Operator's Manual

Header Position Sensor

Located on the right side of the transition is the
header position indicator. It utilizes a linkage
between the face plate and the transition to
indicate the header position relative to the
combine. The position is then displayed in the
corner post of the cab.

Retractable Ladder Step

All Hillside combines are equipped with
retractable bottom steps.
If the ladder does not extend and retract properly
check the fasteners in all of the pivot locations
and make sure they are not over tightened.
Over tightening of these fasteners will cause the
ladder to bind.
Make sure that the gas-charged struts (B) keep
the ladder fully retracted. Replace the struts if
they appear to be weak. If the ladder does not
fully retract, permanent damage may occur
during field operation.
D-180215CMA01C
B
Hillco Technologies, Inc.
15
A
A - Transition Position Indicator
B - Gas-charged Struts
Sept. 2022