Table of Contents
Advertisement
6. Replace the two screws (#6-32x1/4") that secure the power-supply unit bracket to the power-supply unit.
7. Replace the graphics-card bracket and slide the release latch to the lock position.
8. Route the power-supply unit cables through the securing clip.
9. Connect the power-supply cables to the system board.
10. Connect the graphics-card power cables to the power-supply unit.
11. Place the computer in an upright position.
12. Route the power-supply unit cables through the slot on the right side of the computer.
13. Connect the power-supply unit cables to the power-supply unit extension cables on the right side of the computer.
Next steps
1. Install the
right-side
cover.
2. Install the
top
cover.
3. Install the
left-side
cover.
4. Follow the procedure in
Removing the power-supply unit (1350 W)
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
3. Remove the
right-side
4. Remove the
single-graphics
5. Remove the
rear-chassis
6. Remove the
lower front-chassis
NOTE:
Note the routing of all cables as you remove them so that you can route them correctly after you replace the
power-supply unit. The cable management varies depending on the configuration of the graphics card selected.
About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the removal
procedure.
Steps
1. Disconnect the power-supply unit cables from the power-supply unit extension cables on the right side of the computer.
After working inside your
Before working inside your
cover.
cover.
card.
fan.
fan.
computer.
computer.
Removing and installing components
39
Advertisement
Table of Contents
