Kit Contents; Specification - Texas Instruments TMP119 User Manual

Evaluation Module Overview
1 Evaluation Module Overview
1.1 Introduction
The EVM comes in a USB stick form factor, with an onboard MSP430F5528 microcontroller that interfaces with
both the host computer and the TMP119 device. The module is designed with perforations between the sensor
and host controller on the EVM board. The perforation allows the user flexibility in their evaluation:
• The user can connect the TMP119 to the user's system or host.
• The user can connect the EVM host and software to the user's system with TMP119 devices.
• Small individual boards allow the user to place sensors in the user's system.
• Hole spacing is compatible with common 0.1" prototyping breadboards.
This user's guide describes the characteristics, operation, and use of the TMP119 Evaluation Module (EVM). A
complete schematic diagram, printed-circuit board layouts, and bill of materials are included in this document.
This user's guide details through the steps to operate the TMP119 evaluation module.

1.2 Kit Contents

Table 1-1 details the contents of the EVM kit. Contact the nearest Texas Instruments Product Information Center
for missing components. TI highly recommends checking the TI website at
revision.
TMP119EVM
USB Extension Cable

1.3 Specification

Table 1-2 defines the absolute maximum thermal conditions of each section of the EVM. The main two sections
are the controller section and the sensor breakable section. These limits must be considered when evaluating
the performance of the device at extreme temperatures. In this case, if the setup conditions exceed the controller
absolute maximum thermal specifications, then the sensor breakable section must be detached so that only the
sensor (and not the MCU) is evaluated at these temperatures.
BOARD SECTION
Controller board
TMP119 Breakable Board
2 TMP119 Evaluation Module
Table 1-1. Kit Contents
Item
Table 1-2. ISOTMP35BEVM Temperature Limits
CONDITIONS
Recommended operating free-air temperature, T
Absolute maximum junction temperature, T
Recommended operating free-air temperature, T
Copyright © 2023 Texas Instruments Incorporated
https://www.ti.com for the latest
Quantity
1
1
TEMPERATURE RANGE
-40°C to 85°C
A
95°C
J (MAX)
-55°C to 150°C
A
SNOU199 – DECEMBER 2023
Submit Document Feedback
www.ti.com