Table of Contents
Advertisement
WARNING:
or near a lifted product.
•
Attach the lifting equipment at the lifting point of the
safety frame. A label on the product identifies the
correct position.
WARNING:
chains or other lifting equipment with rough
edges that can cause damage to the lifting
eye.
WARNING:
product. Make sure that the safety frame
Weight (uncrated, incl. oil, empty
tanks) kg/lb
Operation weight (EN500, incl. oil, ½
fuel), kg/lb
Engine brand / Type
Engine power, kW/hp @rpm
Vibration frequency, Hz/rpm
Amplitude, mm/in.
Operation speed, m/min / ft./min
Fuel tank capacity, l/qts
Engine oil capacity *, l/qts
1
As specified by the engine manufacturer. The power rating of the engine indicated is the average net output
(at specified rpm) of a typical production engine for the engine model measured to SAE standard J1349/
ISO1585. Mass production engines may differ from this value. Actual power output for the engine installed on
the final product will depend on the operating speed, environmental conditions and other values.
1167 - 004 - 12.09.2023
Do not walk or stay below
Do not use metal hooks,
Do not lift a damaged
Technical data
Rammer shoe width 280 mm/11 in.
91/200
92/203
Yanmar L48V5
1
3/4 @3000
11.5/690
79.3/3.12
11.5/37.7
3.0/3.2
0.8/0.84
and the vibration damping units are correctly
installed and not damaged.
Storage
•
Remove all fuel from the fuel tank before you put the
product in storage for a long period of time. Discard
the fuel at an applicable disposal location.
•
Clean the product before storage. Remove clay and
sand from the rammer shoe. Remove oil and dust
from the rubber parts.
•
Apply a thin layer of oil on the rammer shoe to
prevent corrosion.
•
Clean the air filter before storage.
•
Carefully pull the starter rope handle until there is a
small resistance.
•
Put a protective cover on the product.
•
Keep the product in a dry and frost free area.
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
•
When the product is no longer in use, send it to
a Husqvarna dealer or discard it at a recycling
location.
Rammer shoe width 330 mm/13 in.
92/203
93/205
Yanmar L48V5
3/4 @3000
11.5/690
79.3/3.12
11.5/37.7
3.0/3.2
0.8/0.84
13
Advertisement
Chapters
Table of Contents
