Password Authentication When Tcp Establishes Connection - Waveshare RS232/485 TO WIFI POE ETH (B) User Manual

RS232/485 TO WIFI POE ETH (B) User Manual
1. Automatic framing trigger frame length: refers to RS232/485 TO WIFI POE ETH (B) receiving
the specified number of bytes from the serial port, composing a data frame and forwarding it to the
network.
2. Automatic framing trigger time: It means that RS232/485 TO WIFI POE ETH (B) will forward the
received data to the network if the data received from the serial port is less than the length of the
automatic framing trigger frame within the trigger time.
The time of automatic framing starts from the first byte received by the WIFI serial port server
from the serial port. As shown in the figure below:
The specific UART automATic framing operATion can be set through the "serial port and network
settings-> serial port automATic framing settings" section of the built-in webpage of WIFI serial port
server or by using the at command. For the at command settings, please refer to the introduction of
UARTF/UARTFT/UARTFL commands in the "at command set" chapter of this manual.

6.5 PASSWORD AUTHENTICATION WHEN TCP ESTABLISHES CONNECTION

This function is only applicable to RS232/485 TO WIFI POE ETH (B) as a TCPServer. When the
TCPClient connects to RS232/485 TO WIFI ETH (B), RS232/485 TO WIFI POE ETH (B) will authenticate
every connected TCP.
Figure automatic framing trigger frame length
Figure automatic framing departure time
61
www.waveshare.com