Waveshare RS232/485 TO WIFI POE ETH (B) User Manual page 34

RS232/485 TO WIFI POE ETH (B) User Manual
AT+RELD
(3) Set the WIFI serial server to STA mode, and at this time, the WIFI serial server AP interface is
still valid:
AT+WMODE=STA
(4) Set the parameters for the WIFI serial server to connect to the route (assuming the route
SSID in the figure above is WAVESHARE-WIFI-TEST, the encryption mode algorithm is WPA2PSK, AES,
and the password is www.waveshare. com), as follows:
AT+WSSSID=WAVESHARE-WIFI-TEST
AT+WSKEY=WPA2PSK, AES, www.waveshare.com
(5) Set up SocketA and SocketB
Example of SocketA settings:
AT+NETP=TCP, Server, 8899,10.10.100.100.100
Set the IP and port number of the server to connect to (based on actual parameters)
SocketB settings example:
AT+TCPADDB=192.168.1.100
AT+TCPPTB=18899
(6) Restart the WIFI serial server:
AT+Z
Complete parameter settings.
Precautions:
When the AP+STA function is enabled, the STA port needs to be connected to other routers.
Otherwise, the STA port will constantly scan the router, which will have a certain impact on the AP
port, such as data loss. If the user determines that the STA cannot connect to the AP at this time, he
can use the command to stop scanning the STA port:
AT+STTC=on/off
"On" means to scan the router, and "off" means not to scan. This command will not be saved
after restarting.
AT+FSTTC=on/off
This command can be saved and will take effect after restarting.
The whole AP+STA application can also refer to our official website
FAQ:http://www.waveshare.com/Faq/45.html
34
www.waveshare.com