RS232/485 TO WIFI POE ETH (B) User Manual
Web Page Configuration: Access the built-in web page, navigate to the wireless terminal settings
page, and enable the AP+STA functionality to configure AP+STA settings.
As shown in the figure:
5.2.4 WIRELESS NETWORKING APPLICATION (AP, STA)
The RS232/485 TO WIFI POE ETH (B) device's wireless functionality can be configured in two
modes: as a wireless Station (STA) or as an Access Point (AP). Logically, it supports two wireless
interfaces: one acting as a STA to connect to an existing wireless network, and the other interface
serving as an AP, allowing other STAs to connect to the wireless network through this device.
(6) Restart the WIFI serial server:
The No.1 WIFI serial server works in STA mode and No. 2 works in AP mode:
Figure Wireless networking application (AP+STA)
AT+TCPPTB=18899
35
www.waveshare.com