Table of Contents
Advertisement
Disposal
11.1
Introduction
Protecting the environment and preserving its resources are corporate goals of the highest
priority for us. Our worldwide environmental management system to ISO 14001 ensures
compliance with legislation and sets high standards in this regard. Environmentally friendly
design, technical safety and health protection are always firm goals even at the product
development stage.
Recommendations for the environmentally friendly disposal of the machine and its
components are given in the following section. Be sure to comply with local disposal
regulations.
Country-specific legislation
The machine uses materials that can be recovered or recycled. Correctly separating materials
helps to simply recycle important materials.
• When disposing of the machine or of waste that is created during the individual phases of its
life cycle, please observe the statutory requirements applicable in the country of use.
• Please contact your local authorities for more information about disposal.
11.2
RoHS - restricting the use of certain hazardous substances
In compliance with RoHS ("Restriction of certain Hazardous Substances") we replace substances
that are damaging to the environment by those that are not based on state-of-the-art
technology. In doing so, safety in operation and handling will take priority at all times.
11.3
Note regarding Article 33 of the REACH regulation
Note regarding an obligation to provide information according to Article 33 of the REACH
regulation:
Refer to the delivery note for substances and notes relating to safe handling.
1MB..5/6 shaft height 71 ... 355
Operating Instructions, 11/2023, A5E52779956A
11
151
Advertisement
Table of Contents
