Table of Contents
Advertisement
Assembly
5.5 Installing the machine
5.5.5.2
Diagram showing pulling on and pulling off drive output elements
Only transfer radial or axial forces specified in the catalog to the machine bearings via the
shaft extension.
You can obtain the permissible values for axial and radial forces by contacting the Service
Center (Page 13) or by referring to the machine catalog.
See also
Axial and radial forces (Page 33)
Shaft extensions with feather key
The feather key data for the shaft and drive output element must match and indicate the
correct type of balancing. The drive output element must be correctly mounted.
The balance quality corresponds to vibration severity grade "A" for the complete machine;
vibration severity grade "B" is possible as an option. To ensure the required balance quality, it
74
Withdrawing drive output elements
Mounting drive output elements
1MB..5/6 shaft height 71 ... 355
Operating Instructions, 11/2023, A5E52779956A
Advertisement
Table of Contents
