Table of Contents
Advertisement
Configuring Fluidity Settings using GUI
Access port rules management for outgoing packets with a gateway in smart mode
Packets from the gateways (for example: IoT OD IW
interface)
Signaling traffic
Tagged with valid VID (1–4095), but not with NVID
Tagged with null VID (0) or NVID
Note
Configuring Fluidity Settings using GUI
To change the fluidity settings, follow these steps:
Before you begin
By default, the gateways are shipped from the factory with Fluidity functionality in disabled mode.
Step 1
In the ADVANCED SETTINGS, click Fluidity.
The FLUIDITY window appears.
Step 2
Check the Fluidity check box to enable the fluidity functionality.
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
42
The packets transmitted through the Cisco VIC SFP+ interface is always tagged with a VLAN header. The
outgoing packets from the interface are classified as untagged with an IEEE 802.1p header and VLAN ID tag
of 0.
Configuring Advanced Settings
Packet tagged with MVID
Packet tagged with MVID
Packet allowed (tagged)
Packet allowed (untagged)
Advertisement
Table of Contents
