Cisco IEC6400 Installation And Configuration Manual page 33

Configuring the Gateway Initially in Provisioning Mode
Gateway Fails to Connect to the Network
To verify if the gateway is in provisioning mode and it is not connected to IoT OD IW, use the following CLI command:
Device# iotod-iw show status
IOTOD IW mode: Provisioning
Status: Disconnected
The following CLI example shows that the gateway is in provisioning mode and retrieved the IP address from the DHCP
server:
Device# ip
IP: 192.168.0.10
Network: 255.255.255.0
Device:
Nameservers:
DHCP Address (PROVISIONING Mode):
IP: 10.115.11.29
Network: 255.255.255.0
Device: 10.115.11.1
Nameservers: 8.8.8.8
Fallback Address (PROVISIONING Mode):
IP: 169.254.201.72
Network: 255.255.0.0
The following CLI example shows the gateway in provisioning mode but not able to retrieve the IP address from the
DHCP server, so it uses the fallback IP address of 192.168.0.10:
Device# ip
IP: 192.168.0.10
Network: 255.255.255.0
Device:
Nameservers:
DHCP Address (PROVISIONING Mode):
IP: 192.168.0.10
Network: 255.255.255.0
Device:
Nameservers: 127.0.0.1
Fallback Address (PROVISIONING Mode):
IP: 169.254.201.72
Network: 255.255.0.0
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
27