Changing The Default Login Credentials - Cisco IEC6400 Installation And Configuration Manual

Table of Contents

Changing the Default Login Credentials

Before you begin

Before you login, disable the Wi-Fi on your computer to prevent routing issues between the computer's wired

and wireless network interfaces. The IEC-6400-URWB configurator allows you to configure the IEC-6400

gateway.

Step 1

Power on the gateway and wait for atleast five minutes to allow the boot sequence to finish.

Step 2

Connect one end of a CAT5/6 ethernet cable to the computer and the other end of the cable to the LAN port on the

gateway.

Note

The configurator interface and SSH can be accessible through the data ports 10 and 11 (see

Panel

Step 3

Launch the computer's web browser.

Step 4

To access the configurator, open the web browser and enter the following URL: https://<IP address of gateway>/

The IEC-6400-URWB Configurator login window appears.

Note

The web browser may display security warnings because the IEC-6400 gateway is connected to the computer

using an unsecured CAT5/6 cable connection. Ignoring these warnings is safe and expected during the

configuration process.

Step 5

Enter the username and password in the respective fields. Following are the factory-set login details:

• Username: Cisco

• Password: Cisco

Step 6

Click Login.

•

Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0

View).

Configuring New Login Credentials using GUI

Configuring New Login Credentials using CLI

Log into Gateway Configurator for the First Time

Figure 3: Rear

Table of Contents