Log Into Gateway Configurator For The First Time; Accessing Gateway's Cli From Cimc Cli; Log Into The Gateway Configurator For The First Time - Cisco IEC6400 Installation And Configuration Manual

Log into Gateway Configurator for the First Time

You can log into the gateway configurator using any three of the following methods:
• Using configurator interface or through SSH from data ports using CLI, see
• Using CIMC CLI, see
•
•
•
•

Accessing Gateway's CLI from CIMC CLI

Use CIMC CLI to access the server for configuring the IEC-6400 gateway:
Step 1
To connect with the server through the serial console, use the following CLI command:
Step 2 Enter the username and password.
Credentials are Cisco/Cisco.
Step 3
To retrieve the details of DHCP address in the provisioning mode, use the following CLI command:
Step 4 At first, use the CLI command to set new username and password:
Step 5 Login with default login credentials and then enter the new username and password. For rules on creating the new login
credentials, see
After successful login, the device is in provisioning mode.

Log into the Gateway Configurator for the First Time

Follow the steps to access the IEC-6400-URWB Configurator:
Configurator for the First Time, on page 15
Accessing Gateway's CLI from CIMC CLI, on page 15
Accessing Gateway's CLI from CIMC CLI, on page 15
Log into the Gateway Configurator for the First Time, on page 15
Changing the Default Login Credentials, on page 16
Rules to Reset the Login Credentials, on page 19
Rules to Reset the Login Credentials, on page
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
4
C H A P T E R
device# connect host
device# credentials
19.
Log into the Gateway
device# ip
15