Connecting To Gateway Console Port - Cisco IEC6400 Installation And Configuration Manual

Connecting to Gateway Console Port

Connecting to Gateway Console Port
To configure the gateway locally (without connecting to a wired LAN), connect the computer to the gateway's
console port using a DB-9 to RJ-45 serial cable and to open the CLI by connecting to the gateway's console
port, follow these steps:
Step 1 Connect a nine-pin female DB-9 to RJ-45 serial cable on one side to the RJ-45 serial port on the gateway and the other
side to the COM port on a computer.
Step 2 Set up a terminal emulator to communicate with the gateway. In the terminal emulator, use the following settings:
Parameter
Baud rate
Data
Parity
Stop
Flow Control
Step 3 If you are logging in for the first time, use the standard command prompt (>) mode to execute unprivileged commands.
Use the default username and password to login: Cisco.
Note Once the initial configuration completes, ensure that you remove the serial cable from the gateway.
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
14
Value
115200 bps
Eight bits
No
One stop bit
No
Initial Gateway Setup