MC250
4.4.4 Check and replacement of the parachute
Following the instructions of the manufacturer of the safety device, to ensure the integrity of
the equipment over time, proceed as follows:
Installation of the parachute in the hoist. Test run.
4 YEAR LATER: Send the parachute to the manufacturer for revision and calibration.
8 YEAR LATER: Send the parachute to the manufacturer for revision and calibration.
12 YEAR LATER: Replace the hoist parachute
Adittional equipment information:
brake/
WARNING:
After replacing the parachute, a test must be performed. Write the result in the
instruction manual record.
(+34) 944 71 16 00 (+34) 944 53 17 54 export@alba.es
MC250 Rev.02-USA
Fecha de instalación:
Installation date:
Date de installation:
Fecha de revisión 1:
Revision date 1:
Date de revísion 1:
Fecha de revisión 2:
Revision date 2:
Date de revísion 2:
Fecha de sustitución:
Replacement date:
Date de remplacement:
https://www.eide.net/en/productos/fpc‐overspeed‐safety‐
page
03‐2019
03‐2023
03‐2027
03‐2031
www.alba.es
46 of 78