Logger Function; Freezing The Current Measured Values - PCE Instruments PCE-GPA 50 User Manual

5.3

Logger function

5.3.1 Logging without a time slot
In the settings menu under item 5.1.5.16, no start and stop time must be set.
•
Press the "REC" key to start or stop the logging function.
The data will be saved in the interval set under item 5.1.5.3. The enabled logging function is
shown on the display at the bottom left by the indication "REC".
If there are more than 30000 records, a new file with a new storage name is automatically created.
5.3.2 Logging with time slot preset
•
In the settings menu under item 5.1.5.16, set a start and stop time.
•
Press the "REC" key to start or stop the logging function.
The meter starts the logging function with the interval given in item 5.1.5.3 when the start time is
reached and ends the function when the stop time is reached. The logging function records the
data daily at the set time by pressing the "REC" key meter it is switched off. When the logging
function is switched on, "REC" is shown at the bottom left of the display.
•
By holding down the "REC" key, you can also end the logging function during the active
log phase.
If there are more than 30000 records, a new file with a new storage name is automatically created.
5.3.3 Spontaneous logging with time slot preset
•
If the logging function is enabled, disable it by pressing the "REC" key.
•
Press and hold the "REC" key for 2 seconds to start the logging function.
The meter starts the logging function with the interval set under item 5.1.5.3 directly and stops
the function when the set stop time is reached. The logging function records the data daily at the
set time by pressing the "REC" key until the meter is switched off. When the logging function is
enabled, "REC" is shown at the bottom left of the display.
•
>By holding down the "REC" key, you can also end the logging function during the
active log phase.
If there are more than 30000 records, a new file with a new storage name is automatically created.
If "ChangeSD" is shown at the bottom left of the display, the SD card memory is exhausted or the
SD card has an error.
If "NO DISK" is shown at the bottom right of the display after pressing the "REC" button, insert an
SD card or check that it is correctly inserted.
5.4

Freezing the current measured values

•
Press the "HOLD" key to freeze the currently displayed values.
•
Press the "HOLD" key again to return to the current reading.
The enabled hold function is displayed at the bottom left by the indication "Hold".
© PCE Instruments
20