Step 5, Slide Unit Into Enclosure; Step 6, Remove Toekick And Vent - Monogram ZKST300N Design Manual With Installation Instructions

Installation Instructions
STEP 5| SLIDE UNIT INTO ENCLOSURE
Roll the unit into the enclosure, being careful not to pinch
the water line or power cord.
NN ; me
She SQ
— a
a
¢ A long flat bar or yard stick may be needed to guide the
front edge of the anti-tip bracket over the unit.
If space allows, you may also bend the front edge of the
bracket upward slightly, allowing it to clear the back of
the unit.
u a i :
i i a I
* Remove Top-Center trim cover from unit.
e Secure the unit to the Anti-tip bracket using both
machine screws & washers to engage the threaded
inserts in the anti-tip bracket.
« Hand start the screws until unit is in desired location
within the install space.
e Finalize unit install by tighening the screws fully.
* Reinstall Trim cover.
15
STEP 6 | REMOVE TOEKICK AND VENT
The toekick must be removed to access
the leveling leg system.
e Remove band around EPS block in front of toekick.
* Remove and dispose of EPS block.
# Remove the solid portion of the toekick by pulling forward.
* Place the toekick, vent and screws out of the way so you
will have them for reinstallation.
Vent |
Screws
Vent
(behind i
: 3 525 Sa a= (le
toekick} ——— === OF] — Screw
Screw
—~ Toekick