Installation Instructions
STEP 1; REMOVE
PACKAGING
Ay CAUTION: THE REFRIGERATOR IS
TOP-HEAVY. BE CAREFUL WHEN MOVING.
e Cut bands and tape on the top and bottom
of packaging with a utility knife.
e Unfold the cardboard seams and rernove the top
of the packaging.
e Slide the remainder of the box off of the appliance.
You can use a box cutter to cut the remaining
cardboard being VERY CAREFUL not to scratch
the appliance.
* Remove the Styrofoam supports from around the unit.
* DO NOT remove door band or lower EPS banded
part until unit is ready to go into enclosure.
* Cut EPS skid at the sides near the front from the back
of the unit.
e Push unit forward & remove rear portion of the EPS
skid.
* Carefully lower rear onto the floor.
¢ Lean unit back slightly & remove front portion of the
EPS skid.
¢ Discard all unused packaging materials appropriately.
* The unit can now be moved using an appliance hand
truck or rolled on a properly protected floor by 2
people.
¢ Leave any protective film on the refrigerator until
installation is complete.
13