Sinexcel SEC Series User Manual page 8

manual.
Without Sinexcel permission, do not do any unauthorized modification to the product or

remove of the components. Sinexcel will not be liable for any consequence caused by
these unproper operations.
Do not touch the EV charging connector or vehicle inlet. Keep it dry and clean.

Do not use this product if the power cord or connector is abraded, has broken insulation,

or shows any other signs of damage.
In case of any abnormal condition, press the emergency button immediately, which will

cut all input and output to ensure safety. It is forbidden to use the emergency button in
non-emergency situations.
To make sure that no foreign small object exists in EV charging connector or vehicle inlet.

Do not connect or disconnect power cables with power on. During maintenance, turn off

the superior distributed switch, set up warning board, and check the presence of
dangerous voltage to ensure that it has been properly disconnected.
Pay attention to the copper wire carrying dangerous voltage of equipment, even if all

circuit breakers of the charger has been disconnected.
Before maintenance, prepare for the lumination as there is no light in the interior.

Connect protective earth wire (PE) well before connecting neutral line and phase line.

After installation or maintenance, ensure that door has been locked correct.

After the emergency button is pressed, the operator shall be informed that the charger

cannot be started, and only the operation and maintenance personnel or professional
operators can restart the charger.
It is forbidden to use extension cable or adapter for charging connector.

SEC Series DC Distributed Charger – User Manual
6