Makita HM1801 Instruction Manual
Electric breaker
Hide thumbs
Also See for HM1801:
- Instruction manual (49 pages) ,
- Manual (41 pages) ,
- Technical information (18 pages)
Related Manuals for Makita HM1801
Summary of Contents for Makita HM1801
- Page 1 Electric Breaker MODEL HM1801 MODEL HM1810 006198 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
The tool should be connected only to a power supply of Responsible manufacturer: the same voltage as indicated on the nameplate, and Makita Corporation Anjo Aichi Japan can only be operated on single-phase AC supply. They are double-insulated in accordance with European... -
Page 3: General Safety Rules
The typical weighted root mean square acceleration 8JD, ENGLAND value is 8 m/s Responsible manufacturer: This value has been obtained according to EN60745. Makita Corporation Anjo Aichi Japan GENERAL SAFETY RULES GEA001-2 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. - Page 4 entangled cords increase the risk of electric Power tool use and care shock. Do not force the power tool. Use the cor- When operating a power tool outdoors, rect power tool for your application. The use an extension cord suitable for out- correct power tool will do the job better and door use.
-
Page 5: Specific Safety Rules
SPECIFIC SAFETY RULES GEB004-2 DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to hammer safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Wear ear protectors. Exposure to noise can cause loosen up the lubrication. -
Page 6: Functional Description
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 006199 CAUTION: • Before plugging in the tool, always check to see that the switch lever actuates properly and returns to the “OFF”... -
Page 7: Operation
(1) For bits with a collar 006202 Pivot the tool retainer back and slightly downward. Insert the bit into the Fig.1 tool holder as far as it will go. To securely retain the bit, return the tool retainer to its original position. CAUTION: •... - Page 8 This tool requires no hourly or daily lubrication because it has a grease- packed lubrication system. It should be relubricated after every 6 months of operation. Send the complete tool to Makita Authorized or Factory Service Center for this lubrication service. However, if circumstances require that you should lubricate it by yourself, proceed as follows.
- Page 9 CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
- Page 10 Memo...
- Page 11 Memo...
- Page 12 Makita Corporation Anjo, Aichi, Japan 884604A220...