Makita HM1801 Instruction Manual
Electric breaker
Hide thumbs
Also See for HM1801:
- Instruction manual (49 pages) ,
- Manual (41 pages) ,
- Technical information (18 pages)
Related Manuals for Makita HM1801
Summary of Contents for Makita HM1801
- Page 1 INSTRUCTION MANUAL Electric Breaker HM1801 HM1810 006198 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
END201-5 a fuse or protective circuit breaker having slow tripping characteristics. Symbols The following show the symbols used for the equipment. Be sure that you understand their meaning before use. For Model HM1801 ･ Read instruction manual. ENG102-3 Noise ･... -
Page 3: General Power Tool Safety Warnings
EC Declaration of Conformity and then with 2006/42/EC from 29th December Makita Corporation responsible 2009 manufacturer declare that the following Makita And are manufactured in accordance with the following machine(s): standards or standardised documents: Designation of Machine: EN60745 Electric Breaker The technical documentation is kept by our authorised Model No./ Type: HM1801... - Page 4 Keep children and bystanders away while 15. Do not overreach. Keep proper footing and operating a power tool. Distractions can cause balance at all times. This enables better control you to lose control. of the power tool in unexpected situations. Electrical safety 16.
-
Page 5: Functional Description
27. Keep handles dry, clean and free from oil and WARNING: grease. DO NOT let comfort or familiarity with product GEB004-6 (gained from repeated use) replace strict adherence to safety rules for the subject product. HAMMER SAFETY WARNINGS MISUSE or failure to follow the safety rules stated in Wear ear protectors. -
Page 6: Operation
ASSEMBLY Pivot the tool retainer front and slightly downward. With the notched portion of the bit facing the tool retainer shaft, insert the bit into the tool holder as CAUTION: far as it will go. Then pivot the tool retainer further Always be sure that the tool is switched off and •... - Page 7 This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. It should be 1. Cap rubber relubricated after every 6 months of operation. Send the complete tool to Makita Authorized or Factory Service Center this lubrication service.
- Page 8 If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Bull point • Cold chisel • Scaling chisel • Clay spade • Rammer • Safety goggles • Hammer grease • Hex wrench •...
- Page 12 Makita Corporation Anjo, Aichi, Japan 884604D220...