Table of Contents
Advertisement
7. Align the plastic post (F) inside the Right
Handrail Cover (7) with the indicated hole (G) in
the Right Shield Cover (76).
Press the Right Handrail Cover (7) onto the
Right Shield Cover (76) and the Right Outer and
Inner Shields (17, 19).
Attach the Right Handrail Cover (7) with an
M4 x 16mm Screw (67). Attach the Left
Handrail Cover (6) in the same way.
8. Attach the Rear Upright Cover (21) to the Upright
(2) with five M4 x 16mm Screws (67); do not
tighten the Screws yet.
9. While a second person hold the Console (3)
near the Upright (2), plug the Wires (80, 81, 85)
into the matching receptacles on the back of the
Console.
The connectors on the Wires (80, 81, 85)
should slide in easily and snap into place.
If not, turn the connector and try again. If you
do not connect the connectors properly, the
console may become damaged.
Insert the excess wire into the Upright (2).
Tip: Avoid pinching the wires. Attach the
Console (3) with four M4 x 16mm Screws (67);
start all the Screws, and then tighten them.
7
6
19
8
21
67
9
3
9
7
67
F
76
G
67
2
Avoid pinching
the wires
85
80
2
81
17
67
Advertisement
Table of Contents
