Table of Contents
Advertisement
6. See the left drawing. Insert the tab (E) on one
of the Cover Brackets (18) into the slot (F) in the
Left Upright (89), and attach the Cover Bracket
with two #8 x 1/2" Screws (1).
See the right drawing. Attach the other
Cover Bracket (18) to the Right Upright (90) as
described above. Note: On the Right Upright,
the slot (F) is below the two small holes. The
Cover Bracket will need to be rotated 180º
compared to the Cover Bracket on the left
side.
Then, position the Upright Wire (81) on the left
side of the Right Upright (90) as shown.
7. With the help of a second person, set the
console base assembly (G) on the Right Upright
(90) and the Left Upright (not shown). See the
inset drawing. Position the Upright Wire (81)
so that it is on the inside of the Right Upright as
shown. Do not pinch the Upright Wire.
Next, partially tighten a 5/16" x 3/4" Screw (8)
into the center hole (H) on each side of the
console base assembly (G) and the top of the
Right Upright (90) and the Left Upright (not
shown); do not fully tighten the Screws. Note:
The Screws are used only to hold the console
base assembly in place during assembly.
6
89
F
E
18
1
7
81
90
11
81
90
18
F
E
1
81
G
8
H
90
Advertisement
Table of Contents
