Step 4. Operating The Controls - Kenmore 758.154120 Operator's Manual

Step 4. Operating the Controls
Where you set your desired humidity levels
depends on your personal comfort level, outside
temperature and inside temperature. A starting set
point of 30% - 40% ROOM humidity is
recommended but there may be conditions that
require a different setting.
When Outdoor
Temperature is:
2°F _18°C
10 ° F -12 ° C
20 ° F* -6 ° C *
Recommended Indoor
Relative Humidity (RH) is:
25%
30%
35%
* and above
IMPORTANT: Water damage may result if
condensation starts to form on windows or
walls. Humidity SET point should be
lowered until condensation no longer forms.
We recommend room humidity levels do not
exceed 50%.
To Operate the Controls
Digital Display
Press the power button once to display the digital
readout*. Initially there is a slight delay while the
electronics calibrate.
Two bars (- -) flash during this time.
Once calibration is complete a ROOM humidity
reading between 25% - 95% will be displayed. A
flashing 20 display indicates that the room humidity
is less than 20%.
NOTE: After desired settings are selected by the
user, they remain as long as the unit remains
plugged in and there is no power interruption. If the
unit is unplugged the original default settings are
employed.
* Humidifierfan shouldoperateat initialstart up. If it
does not, refer to, "Fan not operating(digitaldisplay is
illuminated)"in the "TroubleShooting"sectionon page
13 of this manual.
Digital Display
Fan Speed
Humidity Control
7