Operating Humidifier Controls; To Operate The Controls; Water Level Indicator; Fill Indicator - Kenmore Quiet comfort 758.144160 whole house humidifier 12 gallon output Owner's Manual

Operating Humidifier Controls
The operating controls of your Kenmore
Quiet Comfort Whole House humidifier are
located on the top center of the humidifier.
The controls are found under the smoked
control cover, located between the air cir-
culating fans.
Lift the control cover by placing your finger
in the round cutout and lifting. The cover
will stay open. Now you can clearly see the
control area. Familiarize yourself with the
controls and reference the diagram of the
control area for the correct naming used in
this manual.
To Operate the Controls
Humidity Control:
Adjust the amount of humidity depending on
your needs. The humidifier will turn on and
off as required to maintain level of humidity
selected. A medium setting is recommend-
ed, but there are times when a low or high
amount of humidity may be preferred. For
constant operation of humidifier, turning the
control all the way clockwise allows for the
maximum amount of humidity to be evapo-
rated into the air continuously.
IMPORTANT: Water damage may result
if condensation starts to form on win-
dows or walls. Humidity Control setting
should be lowered until condensation
no longer forms.
Speed Control
Your Kenmore humi_r has a three
speed rotary fan control. The higher the
air flow speed, the more water is evapo-
rated and released into the air. Low speed
( • ) is the quietest and is provided for
conditions that may not require as high an
evaporation rate.
Water Level Indicator
This humidifier is equipped with a water level
gauge located in the center of the control panel.
When the cabinet is full of water the large win-
dow opposite the scale will show green. As
water is depleted the amount of green will
decrease to correspond with the scale.
Fill Indicator
When the unit has a small amount of water
left in it, the small window next to Fill on the
control panel will appear orange and the
unit will automatically shut off.
NOTE: The cabinet may have a small
amount of water in it once unit shuts off.
Manual Dryout
At the end of the humidification season or if
Water Gauge Fill Indicator
you do not plan to run the
humidifier for one week or more, you can
override the automatic shutoff function to
completely dry the humidifier cabinet out.
To do this, simply slide the link arm assem-
bly retainer located at the back of the
humidifier cabinet to the top position of the
slot it is located in. This will hold the float in
an upward position and the fans will run until
you turn the power off.
NOTE: Be sure to position link arm assem-
bly retainer to the normal operating mode
(lowest position in slot) for humidifier opera-
tion.
Below is a diagram of the slot the link arm
assembly retainer is located in at the back of
the cabinet.
Back of Oabinet
TOP POSITION
IS FOR MANUAL
DRYOUT
BOTTOM POSITION
IS FOR NORMAL
OPERATION MODE
LINK ARM
ASSEMBLY
RETAINER SLOT