Step 4. Operating The Controls - Kenmore 758.299825C Operator's Manual

Step 4. Operating the Controms
Where you set your desired humidity
levels depends on your personal comfort
lever, outside temperature and inside
temperature. A starting set point of 30% -
40% ROOM humidity is recommended
but there may be conditions that require a
different setting.
When Outdoor
Temperature is:
-10 ° F -24 ° C
2° F -18 ° C
-12 ° C
10 ° F
20 ° F* -6 ° C.
Recommended Indoor
Relative Humidity (RH) is:
20%
25%
30%
35%
_MPORTANT: Water damage may
resurt if condensation starts to form
on windows or waLEs.Humidity SET
point shourd be Eowered untir
condensation no ronger forms. We
recommend room humidity levels do
not exceed 50%.
* and above
To Operate the Controls
Digital Dispmay
Press the power button @ once to
display the digital readout*. Initially there
is a slight delay while the electronics
calibrate.
Two bars (- -) flash during this time.
Once calibration is complete a ROOM
humidity reading between 25% - 95% will
be displayed. A flashing 20 display
indicates that the room humidity is less
than 20%.
NOTE: The default settings at initial
startup are WHSPER fan speed and
{}5% SET humidity. After desired settings
are selected by the user, they remain as
long as the unit remains plugged in and
there is no power interruption. If the unit
is unplugged the original default settings
are employed.
* Humidifier fan should operate at initial start
up. If it does not, refer to, "Fan not operating
(digital display is illuminated)" in the "Trouble
Shooting" section on page 13 of this manual.
Function Buttons
PoweriRefim_" "
Light " Digitam
Display