Step 4. Operating The Controls - Kenmore 758.15408010 Use & Care Manual

Whole house humidifier 8 gallon output with digital readout
Table of Contents

Advertisement

Available languages

Available languages

Step 4. Operating the Controls ▬▬▬▬▬▬▬▬▬▬
Where you set your desired humidity level
depends on your personal comfort level,
outside temperature and inside temperature.
A starting set point of 30% - 40% ROOM
humidity is recommended but there may be
conditions that require a different setting.
IMPORTANT: Water damage
may result if condensation starts
to form on windows or walls.
Humidity SET point should be
lowered until condensation no
longer forms. We recommend
room humidity levels do not
exceed 50%.
To Operate the Controls
Digital Display
Press the power button once to turn the unit
on*
Initially there is a slight delay while
the electronics calibrate.
Two bars (- -) appear during this time. Once
calibration is complete a ROOM humidity
reading between 25% - 95% will be
displayed. A flashing 20 display indicates
that the room humidity is less than 20%
.NOTE: The default settings at initial
startup are (LOW) F1 fan speed and 65%
SET humidity. After desired settings are
selected by the user, they remain as long as
the unit remains plugged in and there is no
power interruption. If the unit is unplugged
the original default settings are employed.
* Humidifier fan should operate at initial start up. If
it does not, refer to "Fan not operating (digital
display is illuminated)" in the "Trouble Shooting"
section on page 12 of this manual.
When Outdoor
Temperature is:
-10° F
2° F
10° F
20° F*
* and above
Quiet Comfort
7
Recommended
Indoor Relative
Humidity (RH)
is:
-24° C
20%
-18° C
25%
-12° C
30%
-6° C*
35%
Function
Buttons
®
Digital Display

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents