Step 2. Location Instructions; Electrical Hook-Up - Kenmore 758.154120 Operator's Manual

Step 2. Location and Electrical Hook-Up
WARNING: For your own safety, do not
use humidifier if any parts are damaged or
missing.
Selecting A Location
Place humidifier on a flat level surface, take extra
care in leveling when placing the unit on carpet.
Position the humidifier where the most humidity is
needed or where the most air will be circulated
throughout the house such as near a cold air
return.
Moist air (humidity) produced will disperse into the
whole house, but the area closest to the unit wilt
have the highest humidity. If the unit is positioned
close to a window, condensation may form on the
window pane. If this occurs the unit should be
repositioned in another location.
NOTE: Due to release of coot, moist air from
humidifier, it is best to direct air away from
thermostat and hot air registers and to position
humidifier next to an inside walt. Unit should not
be placed where cold air from outside walls or
warm air from a hot air register blows directly on it.
Positioning The Unit
The humidifier should be positioned with the back
(cord exit side) and left side, at least 2 inches
away from the wall. Air needs to enter through all
of the louvers in the housing assembly in order for
the humidifier to operate at peak efficiency.
Electrical Hook-Up
Locate nearest 120V A.C. wall socket in the
location desired, preferably on inside wall. With
the humidifier in the desired location, route the
electrical cord safely so no one will trip or upset
the humidifier. Plug in the electrical cord.
To reduce the risk of electrical shock, this
humidifier has a polarized plug (one blade is wider
than the other). This plug wilt fit in a polarized
outlet only one way.
WARNING: To reduce the risk of fire
or shock hazard, humidifier should
be plugged into a 120V A.C. outlet.
Do not use extension cords.
At least 2 inches
from wall
NOTE: Be sure humidistat, which is located on
power cord, is free from obstruction and away from
any hot air source.
If the plug does not fit fully in the outlet, reverse
plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not
change the plug in any way.
5