Advertisement
4.
Cut the wallboard along the mark you made in Step 3 to create the
mounting opening.
5.
Connect the speaker wire from the amplifier to the speaker as
explained in "Making Connects".
6.
Set "Cat Claw" clamps into "ready-to-mount" position depending on
mounting application type:
A.
Wallboard Mounting: "Cat Claw" clamps in EXTENDED
(Default) position.
When the speaker is inserted into wallboard opening, the Cat
Claw clamps will compress and then spring back to extended
position to ease installation.
B.
Backbox Mounting: "Cat Claw" clamps MUST be in
RETRACTED position.
To RETRACT "Cat Claw" clamps, turn each mounting screw on
speaker baffle counterclockwise until Cat Claw has been fully
captured at top of mounting tower
7.
Insert the speaker straight into the mounting opening. Square up the
speaker in the opening and begin tightening the Cat Claw screws on
the front of the speaker baffle.
NOTE:
a.
Turn screws clockwise to clamp / install.
b.
Turn screws counterclockwise to retract / remove.
i.
Cat Claw must be fully retracted to top of
mounting tower to remove speaker.
IMPORTANT: When using power screwdriver – Always use lowest
torque setting to avoid over-tightening the Cat Claw screws.
PerformaBe Architectural Quick Start Guide | rev1.1 20230822 | Features, Specifications, and Appearance subject to change without notice.
A
B
Pg 4 of 6
Advertisement
