Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for REVELL W283
Summary of Contents for REVELL W283
- Page 1 W283, W263, W253L In-Wall Architectural Loudspeaker Instruction Manual...
-
Page 2: About Revel
This document contains general safety, installation and operation the forefront of loudspeaker design and performance. Revel in-wall instructions for the Revel W283, W263, W253L in-wall ® loudspeakers draw upon the same research, resources and unique loudspeakers. It is important to read this document before perspective that put all Revel loudspeakers in a class by themselves. - Page 3 5.1-Channel Surround Speaker Placement Although the Revel W253L is designed for use primarily as front left, center and front right speakers in a home theater system, the high-order • In a 5.1-channel system, the surround left and surround right crossover networks employed in all Revel in-wall speakers provide very loudspeakers should be located to the sides of the main listening smooth response over a wide listening area, allowing you to use any area, 5 ft –...
-
Page 4: Installation Instructions
INStAllAtIoN INStRuctIoNS Press down on the terminal’s tab to open the hole; insert the bare end of the wire into the hole; and release the tab to secure the wire. Revel architectural speakers are extremely easy to install. However, if you are unable to understand and follow the instructions in this manual CAUTION: To avoid short circuits that may damage your clearly and fully, or if you are unsure of your ability to install these... - Page 5 2. Determine the correct speaker location and use the template included 5. Make sure all of the speaker clamps are retracted in their “ready-to- with the speaker to mark the wall material. mount” position at the tops of the mount towers, tucked within the mounting opening's border.
- Page 6 7. Attach the supplied grille. Powerful magnets in the speaker frame will securely hold the grille in place. Be sure that it is attached evenly, and that the edges of the grille extend over the baffle on all sides. Adjusting the tension of the speaker clamps so that the speaker frame is flat will help ensure that the grille contacts the wall all the way around the speaker for a proper fit.
-
Page 7: Obtaining Service
Mounting Opening Mounting Depth Overall Dimensions Dimensions (H x W) (w/grille, H x W x D) W283 11-15/16" x 8-15/16" (303mm x 227mm) 3-11/16" (93mm) 13" x 10" x 3-7/8" (330mm x 254mm x 98mm) W263 9-13/16" x 7-9/32" (249mm x 185mm) 3-7/16"... -
Page 8: Limited Warranty
lImIted WARRANty Revel Series speakers are warranted against defects. The duration of the speaker’s warranty depends on the laws in the country in which it was purchased. Your local Revel retailer can help you determine the length of your warranty. ®...