Operation Of Program Track Timer; Display Mode; Lane-Mode; Rank-Mode - ALGE-Timing Timy3 Manual

5

Operation of Program Track Timer:

•
Switch the Timy on as described in Timy manual GENERAL
•
Select <TrackTimer>
•
Clear the memory with key
•
Input the time of day and date for synchronization and confirm it with
Make a synchronization start (e.g. with key START
•
Now it shows ID-number 1 and the time zero
•
If you want to input another ID-number, do it with the keyboard and confirm it with
•
Start the race with a start impulse (channel 0) or keyboard
•
Stop each competitor with finish impulse device (e.g. manual push buttons)
•
If you get a wrong impulse, or if you want to see other times press
•
After the race is finished, input the next ID-number and confirm it with
•
Check one last setting to be sure that all timing channels are used for the right lanes.
6

Display Mode

You can select between four different mode.

LANE-MODE

RANK-MODE

ALTERNATING-MODE

STANDARD-MODE

6.1 LANE-MODE
The Channel and Lane are the same. You can connect up to 8 GAZ or D-LINE with 7 digit.
The running time will be shown on the display board with address 1.
Lane 1 = Channel 1 = Display address 1
Lane 2 = Channel 2 = Display address 2
etc.
6.2 RANK-MODE
You can connect up to 8 GAZ or D-LINE with 7 digit.. The running time will be shown on the
display board with address 1
Rank 1 = Display address 1
Rank 2 = Display address 2
etc.
6.3 ALTERNATING-MODE
Works on one display board with 8 digit who will show time, rank and lane. The switch for
address adjustment must be on 0.
If the delay time setting is 0, the display board shows only the first stopped time.
To show the next time you have to press the red „OK" button.
6.4 STANDARD-MODE
Display board shows only the stopped time without rank and lane for the duration of the ad-
justed delay time.
Page 8
Timy TrackTimer
or and press key or (red or green).
or
).
.
.
or
(or .
or
, etc.