Advertisement
Other Equipment
HomeLink Wireless Control System
3. Go back to Step 3 of Programming
the HomeLink System to complete
the procedure.
NOTE
If the programming has not been
completed, the system returns to the
previous programming.
Programming two-way
communication
The garage door two-way
communication is a function that
communicates with the garage door
opener and indicates whether the
garages door is open or closed using
the indicator lights in the rear view
mirror. It can indicate the status of the
garage door within a range up-to 250
m (820 ft).
NOTE
The communication range may shorten
depending on obstructions.
Within five seconds after programming
a new HomeLink button, both of the
garage door status indicator lights will
flash rapidly in green indicating that
the garage door two-way
communication has been established.
If the garage door status indicator
lights flash, the two-way
communication programming is
complete.
If the garage door status indicator
lights do not flash, the two-way
communication programming is not
completed. For additional HomeLink
information and programming videos,
refer to the following Websites:
www.HomeLink.com
www.youtube.com/
HomeLinkGentex
7-48
Operating the garage door two-way
communication
By pressing HomeLink buttons 1 and 2
at the same time for two seconds, the
status of the garage door is indicated
for about 3 seconds as follows:
1. HomeLink button 1
2. HomeLink button 2
Garage door
status
Closing
Opening
Closed
Opened
Erasing Programmed HomeLink
Buttons
Press the two outer HomeLink buttons
continuously at the same time until the
indicator light flashes.
Indicator light
Amber flashes
Amber flashes
Green turns on
Green turns on
Advertisement
