Advertisement
Driving
360° View Monitor
Switching the image
1. Turn the commander knob and move the cursor to the desired image.
1. Cursor
2. Press the commander knob to select the image to display.
Viewing the screen
NOTE
Because there might be a difference between the image displayed on the screen
and the actual conditions, always check the safety of the surrounding area directly
with your eyes when driving.
Images may be difficult to see due to the weather and surrounding environment,
however this does not indicate a problem.
The rear view and rear wide view images are reversed left and right.
The actual tires may appear in the top view.
Obstructions displayed in views other than the top view may not be displayed on
the top view.
The areas in black on the top view the seams where each of camera images merge
are blind spots.
The top view is displayed by processing the images taken by each camera.
Therefore, images may be displayed as follows.
Color or brightness displayed on the screen may appear differently than in
actuality.
If the vehicle tilts, the image may appear distorted.
Lines on the road may appear distorted at the seams where each of the camera
images merge.
Screen brightness and contrast can be adjusted.
Refer to the Settings section in the Mazda Connect Owner's Manual.
Refer to Mazda Connect Owner's Manual or consult an Authorized Mazda Dealer.
The parking sensor detection range has limitations. For details, refer to the parking
sensor entry.
Refer to Parking Sensor on page 5-203.
The screen display may differ from the actual display.
5-184
Advertisement
