Select Colors; Adjust Brightness; Section 5. Onetouch Setup; Light Setup - Jandy Infinite WaterColors IWCP50W100 Installation And Operation Manual

Jandy Infinite WaterColors LED Light Controller
® ™
4. Turn zone lights on/off by tapping the toggle to
the right of the desired zone.
4.3

Select Colors

1. Open the app on your device.
2. From the My System page, select your pool.
4.3.1 Select Custom Color
1. Go to > equipment page.
2. From the equipment page, choose the zone you
want to change color.
3. From that zones page, choose Custom Color.
4. Choose your custom color from the color wheel.
5. Choose Apply to apply the custom color to your
zone.
4.3.2 Preset Colors
1. Go to the equipment page and select the zone you
want to change color.
2. After selecting the zone, then choose from the list
of preset colors to apply that preset color to
your zone.
4.3.3 Preset Color Shows
1. From equipment page, choose the zone you want
to change color.
2. After selecting the zone, then choose from the list
of preset color shows to apply that preset color
show to your zone.
4.4

Adjust Brightness

1. From the equipment page, select the sun icon on
the zone where you want to adjust the brightness.
2. Move the slider bar up or down with your finger
and then click apply to change the brightness.

Section 5. OneTouch Setup

5.1

Light Setup

5.1.1 Assign Lights
1. Choose menu on the OneTouch display screen
and press select.
|
Installation & Operation Manual
2.
3.
4.
5.
6.
NOTE: The list will display the last six digits of your Infinite
NOTE: When exiting the Light Zone Setup page, the lights will
5.1.2
1.
2.
3.
4.
5.
5.2
1.
2.
3.
NOTE: To turn off lights, re-select the light zone and wait 5
NOTE: Custom color can only be adjusted using the
From the menu screen, go to > System Setup >
IWC Lights.
Select zone set up.
From the IWC Lights Zone Setup screen, choose
Assign Zone.
From the IWC Lights screen, choose your device
(light controller) from the list to assign lights to a
light zone.
A list of lights currently connected to the light
controller will appear, select a light and assign it
to a light zone (up to 4 zones).
WaterColors LED Light Contorller serial number
located on the bottom of your controller.
turn off
Name Light Zones
Choose menu on the OneTouch display screen
and press select.
From the menu screen, go to > System Setup >
IWC Lights.
From the IWC Lights screen, select Zone Setup.
From the IWC Lights Zone Setup screen, choose
Zone Name.
From the IWC Lights Rename screen, choose the
zone you want to name and enter the name.

Select Color

Choose equipment on the OneTouch display
screen and press select.
Scroll through the menu and select the desired
light zone.
From the list of preset colors and color shows,
select the desired color.
seconds.
iAquaLink app.
ENGLISH
Page 9