Part : Installation And Preparations For Use - Nordmende CTG51LPGBK Operating And Installation Instructions

3. Part : INSTALLATION AND PREPARATIONS FOR USE

This modern, functional and practical oven, that was manufactured with the
parts and materials of highest quality, will meet your cooking needs in every
aspect. You must surely read this manual so that you don't have any problem in
future and to be able to have satisfactory results. The following information are
the required rules for right installation and service processes. It must be read
especially by the technician who will install the appliance
Contact To Authorized Service For Installation Of Your Oven
3.1 Environment where your appliance will be installed
Your oven must be set up and used in a place where it will always have
•
ventilation .
There must be a natural ventilation enough to provide the gas to be used in
•
the environment. The average air flow must directly come in through the air
holes that will be opened on the walls that are opened towards outside.
These air holes must have at least the effective cross section of 100cm for
fresh air circulation (One or more air holes can be opened.). This hole (or
holes) must be opened so that they are not blocked. Preferably they must be
placed close to the bottom and at opposite side of the smokes of the burned
gases that were emptied. If it seems not possible to open these ventilations
in the place where the appliance is set up, the needed air can also be
obtained through the next room, provided that this place is not a bed room
or a dangerous place. In this case this "next room" must also be ventilated
as required.
Emptying of the Burned Gases from Environment
The cooking appliances that operate with gas, throw the burned gas wastes out
directly to the outside or through the cooker hoods that are connected to the a
chimney that opens directly to the outisde. If it seems not possible to install a
cooker hood, it is required to set an electric fan on the window or wall that has
Air inlet section
2
min. 100cm
Figure 1
Air inlet section
min. 100cm
6
.
2
Figure 2
2