Nordmende CTG51LPGBK Operating And Installation Instructions page 15

3. Part : INSTALLATION AND PREPARATIONS FOR USE
Changing injectors:
Hob Burners :
Cut off the feeding gas flow and electric current
•
Remove the hob cap and the adapter.
•
Unscrew the injectors. For this, use a 7mm spanner.
•
Replace the injector with the ones from the spare set, with corresponding
•
diameters suitable to the type of gas that is going to be used, according to
the information chart (which is also supplied in the spare set).
Oven/Grill Injectors
The oven and grill injectors are assembled by a single screw that is placed on
the tip of the burner. For grill burners, this screw is already visible. Remove the
screw, pull the grill burner to yourself and you will see the injector revealed on
the rear surface of the oven cavity.
For oven burners, open the drawer compartment and you will see the assembly
screw below the burner. Remove the screw, move the burner diagonally and the
injector will be revealed on the rear side of the burner box.
Remove the injectors with a 7mm spanner and replace the injector with the
ones from the spare set, with corresponding diameters suitable to the type of
gas that is going to be used, according to the information chart (which is also
supplied in the spare set).
:
Figure 9
.
Figure 8
12
Figure 10