Advertisement
3. Withthe helpofa second person, c arefully tipthe
Uprights (64)backtothevertical p osition.
3
Attach the Latch Assembly (32) to the left Upright (64)
with the two Screws (33).
33
4
33
32
-64
4. Insert a Handrail Extension (34) into the post on the left
Upright (64) as far as possible. If necessary, tap the
Handrail Extension with a rubber mallet to fully insert it.
Next, attach the Handrail Extension by tightening three
Extension Screws (35) into the indicated holes.
Identify the Left Foam Grip (31) (see the inset drawing).
Remove the paper from the two indicated pieces of Foam
Tape (82). Apply a small amount of water to the pieces of
Foam Tape. Slide the Left Foam Grip as far as possible
onto the post on the left Upright (64). Press two Plastic
Fasteners (9) into the Foam Grip and the Handrail
Extension (34). If neccessary, use a blunt object to press
in the Fasteners.
Attach the other Handrail Extension (not shown) and the
Right Foam Grip (43) as described above. Note: Make
sure that the Extension Screws (35) are attached on the
outside of the post as shown.
31
Post_
34
82
5. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure pface; the allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet
from damage, place a mat under the treadmill.
7
Advertisement
