Advertisement
Duringheart r atepro-
grams, t heprogram
displaywillshowa
graphic thatrepresents
yourheartrate.Each
timea heartbeat isde-
tected,anadditional
peakwillappear.
ooooooo!
III
oooooool
II
eoooooel
III
_oooo.ooj jj I
I
D
Enter your age.
When a heart rate pro-
gram is selected, the let-
ters AGE and the current
age setting wit1 begin to
flash in the Calories/
Fat Calories/Heart
Rate
display. You must enter your age to use a heart
rate program, If you have already entered your
age, go to step 5. If you have not entered your
age, press the Incline (Age Set) buttons until your
age is shown. Your age will then be saved in mem-
ory,
I
_EARTRATEV
I
I
CALORIES
FAT CALS
[_'_ Press the Start button or the Speed A button to
start the program.
A moment after the button is pressed, the tread-
mill will automatically
adjust to the first speed and
incline settings for the program, Hold the handrails
and begin walking.
Each heart rate program is divided into one-minute
segments. (The Time/Incline/Segment
Time dis-
play will show both the time remaining in the pro-
gram and the time remaining in the current seg-
ment of the program.) One target heart rate set-
ting is programmed for each segment. (The same
target heart rate setting may be programmed for
consecutive segments.)
When only three seconds remain in the first seg-
ment of the program, a series of tones will sound
and the Time/Incline/Segment
Time display and
the Speed/Min-Mile display will flash. In addition,
the speed and/or incline of the treadmill will change,
if needed, to bring your heart rate closer to the tar-
get heart rate setting for the next segment. The
program will continue until no time remains in the
program. The walking belt will then slow to a stop.
If the speed or incline setting for the current seg-
ment is too high or too low, you can adjust the set-
ting with the Speed or Incline buttons. However, if
you decrease the speed, the incline will automati-
cally increase; if you increase the speed, the in-
cline will decrease. If you increase the incline, the
speed will decrease; if you decrease the incline,
the speed will increase. The treadmill will always
attempt to keep your heart rate near the target
heart rate setting for the current segment. Note:
When the incline reaches the lowest setting, the
speed cannot be increased any further. When the
incline reaches the highest setting, the speed can-
not be decreased any further.
If your pulse is not detected during the program,
the letters PLS will flash in the Calories/Fat
Calories/Heart
Rate display and the speed and in-
cline of the treadmill may automatically decrease
until your pulse is detected. If this occurs, refer to
the instructions included with the chest pulse sen-
sor.
Q
To stop the program at any time, press the Stop
button. Heart rate programs should not be stopped
temporarily and then restarted. To use a heart rate
program again, reselect the program and start it at
the beginning.
Follow your progress with the displays.
Refer to step 5 on page 10.
B
When the program is completed, remove the
key from the console.
Refer to step 6 on page 13.
14
Advertisement
