Table of Contents
Advertisement
Installation Procedure
b Set the SEG22 value by pressing the
value you want to set appears on the remote control display.
When you press the
following order:
18 Press the
(Mode) button. Heat and Off appear on the remote control display.
19 Set the SEG23 and SEG24 values:
a Set the SEG23 value by pressing the
value you want to set appears on the remote control display.
b Set the SEG24 value by pressing the
value you want to set appears on the remote control display.
When you press the
following order:
3 Check whether the option values that you have set are
correct by pressing the
[SEG2, SEG3]
[SEG4, SEG5]
[SEG11, SEG12]
[SEG14, SEG15]
[SEG21, SEG22]
[SEG23, SEG24]
30
English
Steps
(High Fan) button repeatedly until the
(Low Fan) or
(High Fan) button, values appear in the
(Low Fan) button repeatedly until the
(High Fan) button repeatedly until the
(Low Fan) or
(High Fan) button, values appear in the
(Mode) button repeatedly
[SEG6, SEG8]
[SEG9, SEG10]
[SEG16, SEG17]
[SEG18, SEG20]
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor
on the indoor unit and then press the
button on the remote control twice. Make sure that
this command is received by the indoor unit. When it is
successfully received, you can hear a short sound from
the indoor unit. If the command is not received, press
the
(Power) button again.
5 Check whether the air conditioner operates in
accordance with the option values you have set:
a Reset the indoor or outdoor unit.
Indoor unit : Press the
(Low Fan) buttons on the remote control
simultaneously for 4 seconds.
Outdoor unit : Press the K3 button.
b Remove the batteries from the remote control,
insert them again, and then press the
button on the remote control.
Remote control display
SEG22
SEG23
SEG24
(Power)
(Set) and
(Power)
Advertisement
Table of Contents
